Banner Banner Banner Banner
Concrete Mould Oil
GRADES: 5 and 22
Concrete Mould Oil
Introduction of Concrete Mould Oil :
Concrete Mould Oil are high quality mineral oil based mould releasing oil with low odour as multi-purpose mould releasing agents for metallic and wooden moulds in concrete construction works. Concrete mould oil form a tenacious oily film on the mould surface that prevents rusting of mould and the release agents prevent concrete clinging to the moulds with a high quality surface finish. Concrete mould oil do not cause stain or discolouration, interfere with drying process and is also not absorbed by the concrete.
Application of Concrete Mould Oil :
Concrete Mould Oil are used straight from the drum and no stirring or mixing is required. Concrete mould oil are applied by spraying guns, rollers or by brushes prior to pouring aerated concrete and are recommended for use as a concrete mould release agent with the protection of moulds from rust.
Typical Properties of Concrete Mould Oil :
CHARACTERISTICS Concrete Mould Oil
5 22
Kinematic Viscosity @ 40°C, cSt. 4.5 to 5.5 20.0 to 24.0
Colour, ASTM, Max. 3.0 3.0
Flash Point, °C, COC, Min. 120 160
Pour Point, °C, Max. -3 -3
Packing of Conmol Oil :

210 Litres Drums.

 

Date of Issue : DKG/14.06.2008

DISCLAIMER: The information given here is considered to be correct & is offered for your consideration, investigation & verification. No Warranties are expressed or implied, since the use of products are beyond our control.

Quality/Policy

 

Technical Support

 

Our Prouduct Range

 

Highlights